Generator Installation in Shoreham

The physical generator installation is usually the shortest part of the process. Once permits are approved and the equipment is on site, most residential installations, including pad work, electrical connections, transfer switch wiring, and fuel line work, are completed in a concentrated window of a day or two for a typical home. The full timeline from your first consultation to a commissioned, inspected system generally runs longer, because permitting timelines, inspection scheduling, and utility coordination are controlled by outside parties. Complex sites, panel upgrades, or new gas service can extend it further. StandTech Electric gives you a realistic timeline at the proposal stage based on your specific jurisdiction and scope, and we keep you updated as each milestone clears rather than leaving you to wonder where things stand.

Correct sizing depends entirely on what you want running during an outage, and it is the single most important decision in a generator installation. A system covering essential circuits, meaning your refrigerator, furnace or boiler controls, sump pump, well pump, and some lighting, requires far less capacity than a whole-home system running central air conditioning, an electric range, and every room at once. Sizing also has to account for inrush current, the brief surge that motors draw at startup, which can be several times their running load. This is why the 80 percent rule matters: a generator should not be continuously loaded past roughly 80 percent of its rated capacity, because sustained operation near maximum accelerates engine wear and shortens equipment life. Our electricians perform a full load assessment before recommending any unit so your generator operates comfortably within its designed range.

No, and this is genuinely dangerous rather than merely against the rules. Connecting a generator to your home without a transfer switch, whether through an outlet or directly into the panel, can cause backfeeding, where electricity travels backward through the utility lines. Backfeeding can energize lines that utility crews believe are dead, and it can cause fires and equipment damage inside your own home. It also violates electrical code. A permanent generator installation requires an automatic transfer switch, which physically disconnects your home from the utility grid before the generator supplies any power and reconnects only after utility service is confirmed stable. There is no compliant shortcut around this component, and any contractor willing to skip it is not one you want touching your electrical system.

It depends on age, service history, and whether the unit still fits your home's electrical demand. Generators are engines, and like any engine they reach a point where accumulated repair costs exceed the value of the machine. If your unit is well past a decade of service, requires repeated service calls, fails its scheduled exercise cycles, or was sized for a home you have since expanded with an EV charger, a heat pump, or a finished basement, replacement is often the better long-term decision. If the unit is otherwise healthy and the issue is a battery, a controller, a transfer switch fault, or a wiring problem, repair usually makes more sense. StandTech Electric evaluates the existing system, explains what we find, and gives you an honest recommendation rather than defaulting to whichever option is larger.

Standby generators are designed to sit idle and then perform flawlessly on demand, which is exactly why maintenance matters. Most units run a scheduled self-exercise cycle to circulate oil and keep the engine ready, and that cycle is set during commissioning. Beyond that, generators need periodic oil and filter service, battery inspection and eventual replacement, air filter and spark plug attention on the manufacturer's interval, and a general check of the transfer switch, connections, and enclosure. Batteries are the most common cause of a generator failing to start when needed, which is why they are worth checking rather than assuming. As a full-service electrical contractor, StandTech Electric can address not only the generator itself but any panel, wiring, or transfer switch issue contributing to a problem, so you are not coordinating between multiple companies to solve one fault.